1 IN BOSS CLAMP

Dixon® 4-Bolt Clamp, Series: Boss™, 1 in Inside Dia, 1-34/64 to 1-46/64 in Outside Dia, 2-7/8 in Length, 3-1/8 in Width, 9/16 in Hex Bolt, 21 ft lb, Iron Band, Zinc Plated, Domestic

• Recommended for steam service up to 450 deg F
• Replacement nuts and bolts are available
• Two gripping fingers and two clamps sections
• The bolts used in the boss interlocking clamps are not standard bolts
• They vary from standard bolts in their lengths, diameter, overall thread lengths and materials hardness
• These bolts can be retorqued, but it is not recommended to reuse the bolts or clamps, as they are designed for a single bend only
• Torque values for clamps are based on dry bolts
• The use of lubricant on bolts will adversely effect clamps performance
• Do not lubricate nuts and bolts
• Bolts in boss clamps are designed to bend as they are tightened and this allows the clamps to conform to the hose outside diameter
• Always tighten bolts to their specified torque values
• Periodic re-tightening of bolts is required due to "cold flow" phenomenon present in all rubber hoses
• Boss clamps are for single use only, once removed they are to be discarded
• Warning: this products contains a chemicals known to the State of California to caused birth defects or other reproductive harm
• Do not use in connections with drinking water
• Wash hands after handling